Jenn-Air SCE30600 Use And Care Manual page 42

Beforereplacingbulb, disconnectpower tooven at the mainfuse or circuitbreakerpanel
andat the electricreceptacle. Be surethat the entire ovencavity includingthe light bulb
is cool before attempting to remove.
To replace light bulb
1. Carefully unscrewthe glass light lens.
2. To obtain firm grasp on the bulb, wear protective
rubber gloves. Removeby turning bulb to the left. J"
Do not toucha hot ovenlight bulb with a dampcloth
as bulb willbreak. Note: If the bulb doesbreakand
you wish to remove it, be certain power supply is
disconnected and wear protective gloves. You
may contact your authorized Jenn-Air Service
Contractor for service.
3. Replace bulb with a 40 watt oven-rated appliance
bulb. A bulb with a brass base is recommendedto
prevent fusing of bulb into socket.
4. Replace bulb cover and reconnect power to oven.
Reset clock.
The storage drawerat the bottomof the range is safe
and convenientfor storing metal and glass coekware.
DO NOT store plastic, paperware, food or flammable
materialin this drawer. Removedrawer to clean under
range.
To remove: Empty drawer and then pull drawer all the way out to the stop position.
Grasp sides and lift up and out to remove drawer.
To replace: Fit ends of drawer glides onto rails. Lift up drawer front and gently slide
drawer to the closed position.
Some floors are not level. For proper baking, your _ I i J
range must be level. Leveling Jegsare located on
each cornerof the baseof the range. Levelby turning
the legs.
To prevent range from accidently tipping, range must be secured to the floor by sliding
rear levelingleg into the anti-tip bracket suppliedwith the range.
42