Esata Device Connection - Samsung SVR-3200 Install Manual

3.3.4.2

eSATA device connection

Use the eSATA port in the back of the DVR unit to connect your SVS-5E external HDD. External
storage requires its own power source as the DVR unit does not supply power to it.
Since some external devices may not be recognized if connected with the DVR
unit on, the following procedure should be followed.
1. Turn DVR power OFF.
2. Connect external device and eSATA interface cable.
3. Turn external device power ON.
4. Turn DVR Power ON.
3.3.4.3 Supported HDD
Refer to the appendix in the back of the manual for information on supported HDDs.
3.3.4.4 Registering & formatting HDDs
When the DVR is first booted after a new HDD is physically installed, the "Disk Manager"
automatically runs as shown in the following figure.
If the "Disk Manager" does not run, check that the HDD is properly installed.
(1) Press [Enter] with "Disk Manager" selected.
(2) Press [▲/▼] to select the new HDD ("No" under the "Enabled" column heading), and then
press [Enter].
41
Install Manual