ProForm 485 Crosswalk User Manual page 7

1. Make sure that the power cord is unplugged.
Position the Base (52) and the Base Extensions
(45, 120) upside-down as shown.
Attach six Base Feet (63) to the Base (52) and
the Base Extensions (45, 120) with six #8 x 1"
Tek Screws (26).
2. Have a second person hold the Base (52) in the
position shown.
Identify the Right Upright (54) which has a
square hole near the lower end.
Hold the Right Upright (54) so the two round
holes are on top as shown. Attach the Right
Upright to the Base (52) with two M10 x 75mm
Bolts (2) and two M10 Star Washers (9). Do not
fully tighten the Bolts yet.
Attach the Left Upright (53) to the Base (52) in
the same way.
3. Attach the Right Base Extension (45) and the
Left Base Extension (120) to the Base (52) with
four M8 x 58mm Bolts (13), four M8 Flat
Washers (32), and four Base Extension Nuts
(43).
Lower the Base (52) so that it is flat on the floor.
1
26
63
26
63
45
63
26
2
Round Holes
53
3
120
13
32
7
26
52
63
63
26
63
120
Round Holes
Square
Hole
54
52
9
2
32
13
52
43
26
2
9
45
43