Messages Displayed When Using The Printer Function - Ricoh MP 401 spf User Manual

10. Troubleshooting
Message
"The email destination(s)
which is registered to the
program cannot be recalled
because there is a problem
with the Digital Signature's
device certificate."
• If "Check whether there are any network problems." appears, the machine is not correctly
connected to the network or the settings of the machine are not correct. If you do not need to
connect to a network, you can specify the setting so this message is not displayed, and then the
[Check Status] key no longer lights. For details about how to do this, see "Parameter Settings", Fax
. If you reconnect the machine to the network, be sure to set "Display" by configuring the
appropriate User Parameter.
• If the paper tray runs out of paper, "Cannot print fax message. Load paper." appears on the
screen, asking you to add paper. If there is paper left in the other trays, you can receive documents
as usual, even if the message appears on the screen. You can turn this function on or off with
"Parameter Settings". For details about how to do this, see "Parameter Settings", Fax
When the memory becomes full while using the facsimile function
Message
"Memory is full. Cannot scan
more. Transmission will be
stopped."

Messages Displayed When Using the Printer Function

This section describes the principal messages that appear on the display panel, error logs or reports. If
other messages appear, follow their instructions.
180
Causes
There is no device certificate
(PDF with digital signature),
or the certificate is invalid.
Causes
The memory is full.
Solutions
A new device certificate (PDF with
digital signature) must be installed. For
details about how to install a device
certificate (PDF with digital signature),
see Security Guide .
Solutions
If you press [Exit], the machine returns
to standby mode and starts transmitting
the stored pages. Check the pages that
have not been sent using the
Communication Result Report, and
then resend those pages.
.