True Fitness TREADMILL 2011 Service Manual page 22

E5 Sensor (Belt moves for 5-10 seconds) Cont.
Check to see if the speed LED flashes on the lower board when
moving the belt by hand.
If there is a flashing speed LED on the lower board, enter calibration
and check for speed feedback in the upper panel display.
Check the data cables for continuity or try a known good 20 pin cable
between the MCB and the Smart Board and the 10 pin console
cable. If there is still no speed feedback in the upper panel, replace
the upper panel.
E5 Sensor ( only occurs under load)
Most common cause his high belt and deck friction. Perform amp
draw test on pg: 29
Proprietary & Confidential Proprietary & Confidential
TRUE Fitness Technology, Inc. TRUE Fitness Technology, Inc.
E5 SENSOR
Tread Service Manual - July 2011
22