Xerox DOCUPRINT N4525 Advanced Features And Troubleshooting Manual page 43

Ethernet Menu Items (cont'd.)
Sub Net Mask Sets the four byte Sub Net Mask address. (This menu item only appears if
Address Res
Values:
Note: Once the control panel shows
Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address.
Default Gateway Sets the four byte Default Gateway address. (This menu item only appears if
IP Address Res
Values:
This item only appears if IP Address Res. is set to
Note: Once the control panel shows
use the Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address.
Port Timeout Sets the time for determining when to end an incomplete print job and poll
the next port in the polling sequence. This menu item also causes an implicit
job end (such as Control D in PostScript or <ESC> E in PCL) and invokes the
emulation functions associated with this action (e.g., formfeed, reset, etc.).
Values (in seconds):
The value changes by 1 each time you press either Value key (labeled 3 or
7). Hold down either key to scroll quickly through the values.
Speed Sets the speed and half/full duplex mode of the 10/100BaseT Ethernet
interface. (This menu item does not appear when the 10Base2 Ethernet
interface is installed.)
Values:
9100 Timeout Sets the timeout for the AppSocket Port 9100 communications protocol.
Values:
Advanced Features and Troubleshooting Manual
is set to
static
xxx.xxx.xxx.xxx
where = to
xxx 000 255
is set to
xxx.xxx.xxx.xxx
where = to
xxx 000 255
- (default is )
5 300 30
(default)
Auto
10/Half
10/Full
100/Half
100/Full
(default)
On
Off
Control Panel Menus
.)
Sub Net Mask on the top line, use the
.)
static
Static
Default Gateway
IP
.
on the top line,
27