Xerox DOCUPRINT N4525 Advanced Features And Troubleshooting Manual page 36

Control Panel Menus
System Menu Items (cont'd.)
Output Timeout Specifies whether the printer waits after a bin is filled or directs output to an
alternate bin.
Values:
Output Offset Specifies whether output from jobs is offset in the Face-down Bin and
Finisher Output Bin (if installed).
Values:
Note: Output cannot be offset in the optional Face-up Bin.
Output Dest Sets the default paper output destination for PCL and PostScript jobs.
Values:
Staple Mode Selects the default staple position. (Only appears when the Finisher is
installed.)
Values:
Refer to the User Guide for information on stapling positions.
Punch Sets the default operation of the hole punch option. (Only appears when the
Finisher is installed.)
Values:
Print PS Errors Specifies whether to print an error page whenever a PostScript error occurs.
Values:
Power Saver Specifies the number of minutes of inactivity before the printer enters a
low-power state.
Values: (in minutes)
20
Off (printer waits after a bin is filled)
(default - printer directs output to an alternate bin)
On
Off (default - output not offset)
(output offset)
On
Face Down Bin (default)
(only shown if optional Face-up Bin is installed and
Face Up Bin
enabled)
(only shown if optional Finisher is installed)
Finisher Bin
(default - no stapling)
Off
(Front)
Position 1
Position 2 (Rear)
(Two in middle)
Dual
(default)
Off
On
(default)
Off
On
(never enter Power Saver mode)
Off
15
30
60 (default)
90
120
180
DocuPrint N4525 Network Laser Printer