Configuring Cb3000 Wlan Settings - Motorola CB3000 Quick Install Manual

2-8 CB3000 Client Bridge Quick Install Guide
6. Enter a default user name of 'admin' and a default password of 'symbol'. Click
The Information screen displays high level device name and network address information. The page is read-
only with no configurable data fields. The CB3000 is now ready to have its WLAN settings configured, then
its Ethernet Settings. For more information, see sections
Configuring CB3000 Ethernet

Configuring CB3000 WLAN Settings

Use the WLAN Settings screen to define a CB3000 network (operating) mode of either Infrastructure or
Ad Hoc, select the ESSID (Wireless LAN Service Area) for CB3000 connection and assess the available
networks available for CB3000 connection.
NOTE: The WLAN settings for the CB3000 must be configured before Ethernet settings or any other
configuration.
Use Infrastructure mode to interoperate with an access point (AP). Using the Infrastructure mode, the CB3000
can roam freely between AP cells within the network. Infrastructure mode is the CB3000 default mode.
CAUTION: Do not connect a CB3000 in Infrastructure mode directly to a LAN (for example, through a wall
port). Such a connection could cause a transmission loop between the CB3000 and its associated access
point, disrupting network connectivity.
Select Ad Hoc to form peer-to-peer CB3000 networks without using access points. Use Ad Hoc mode to
create networks within established network coverage areas or networks free of the physical constraints of
access point provided radio coverage areas.
NOTE: For the scope of the basic CB3000 configuration discussed in this guide, only a CB3000
Infrastructure mode configuration is described. For information on configuring the CB3000 for Ad Hoc
(Peer-to-Peer) operation, refer to the CB3000 Client Bridge User Guide available on your product CDROM
or at the Motorola Web site (http://www.symbol.com/services/downloads).
Settings.
OK.
Configuring CB3000 WLAN Settings and