CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
STEP 14: Unit Leveling (if needed):
a) Ensure treadmill incline
rack wheels and rear feet are
resting on the floor.
b) Using a 15/16 inch
open end wrench, loosen
nut (A) the Rear Foot.
c) Using a level or estimating by
sight, turn section (B) of foot
clockwise, or counter-clockwise,
using a 7/8 inch open end wrench to
level the unit.
d) Tighten nut (A) until it is secured
against bottom of treadmill.
STEP 15: Attach Safety Key:
NOTE: The safety key and
attachment cord are wrapped around
plate during shipping as shown.
a) Unwind safety key and cord from
plate.
c) Attach Safety Key magnet to front
of Center Pod as shown.
d) Attach Safety Key clip to plate
located on Console Rack (when not
working out).
e) Attach clip to clothing at the
beginning of any workout.
CAUTION: Read treadmill Owner's
Manual before attempting any
workout.
MAGNET
Truefitness.com / 800.426.6570 / 636.272.7100
A
B
CLIP
LANYARD
ATTACHED
TO PLATE
22