True CS400 Owner's Manual page 17

CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
STEP 3-1: Frame Cable Connections:
a) Route the COAX Cable and
COMM Cable to the front of the
treadmill frame.
b) Connect the COMM cable to the
Connect COMM
network jack on the power plate as
Cable Here
shown.
c) Remove nut and washer from front
of COAX Cable as shown.
Washer
d) Pass front of COAX Cable through
hole in electrical panel and install
washer and tighten nut using 1/2 inch
open end wrench on nut and long
Nut
nose pliers on connector portion of
cable.
Pass COAX Cable
Through Here
Step 3-2A Frame Cable Connections:
*LED CONSOLES & 9" TFT CONSOLES ONLY
a) Ensure the AUXPS cables that are
attached to the CNTRL cable are
Make CNTRL /AUXPS
firmly connected.
Connection Here
b) Connect the CNTRL / AUXPS
cable bundle to the smart board as
shown.
Truefitness.com / 800.426.6570 / 636.272.7100 13