True CS400 Owner's Manual page 18

CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
Step 3-2B Frame Cable Connections:
*TOUCHSCREEN CONSOLES & 15" TFT CONSOLES ONLY
a) Place Auxiliary Power Supply
TCPS Power Supply
(included in console box), in motor
Connector
area floor location shown.
b) Connect TCPS Power Supply AC
connector (large connector w/ 3 pins)
into Auxiliary Power Supply as shown
in picture. Make sure connector is
Wire Ties
fully inserted.
c) Secure Auxiliary Power Supply to
floor using the supplied wire ties.
NOTE: The Auxiliary Power Supply
will be pre-installed in 220v units.
d) Separate the AUXPS cables that are
attached to the CNTRL cable and cut
the wire tie holding the female end of
the AUXPS cable to the CNTRL cable
as shown.
Cut Wire Tie
e) Connect the female end of the
AUXPS Cable coming from Pedestal
AUXPS Connection
Make CNTRL
to AUXPS Power Supply Cable.
Made
Connection Here
f) Connect the CNTRL cable to the
smart board as shown
NOTE: The male end of the AUXPS
cable wire tied to the CNTRL cable is
not used for this installation.
Truefitness.com / 800.426.6570 / 636.272.7100 14