Install A Magstripe Reader (Optional); Program Default Parameters - Symbol LS 3070 Quick Reference Manual

Q u i c k

8. Install a Magstripe Reader (Optional)

If desired, install a magstripe reader. Do this either before or after
pairing.
Remove the blank plug in the magstripe connection port on the
base/charger, and then plug the magstripe reader's cable into this
port. The blank plug protects the base/charger from accidental
damage due to static electrical discharge into the magstripe
connection port. Do not remove the plug unless installing a
magstripe reader, and replace the plug into the port whenever the
magstripe reader is removed.
Magstripe
Connection Port

9. Program Default Parameters

Scanning the SET DEFAULTS bar code returns all parameters to the
values listed in the Default Table, which appears at the end of this
document.
Other customized programming must be performed through bar
codes available in the LS 3070 Product Reference Guide or
Advanced Programmer's Guide.
With this set, you are ready to scan bar codes.
R e f e r e n c e
SET DEFAULTS
21