Engine Oil Level Inspection; Engine Oil Replacement - Yamaha XC200T Service Manual

f lNSP]
ENGINE OraL LEVEL MNSPECTION/
ADJ
ENGtNE OIL REPLACEMENT
r, ENGINE OIL LEVEL iNSPECTION
1. Remove:
®Front cover
*Side cover (Left) _
Refer to "REMOVING THE COVERS AND
PANELS", page 2q2.
2. Inspect:
! ®Engine oil level
/
\.
/....
Oil level low-_Add sufficient oil.
Engine oil leve_ inspection steps:
[
t I[ *Place the scooter on a level place.
|' {2b___ °
I:1
*Warm up the engine for serveral minutes, and
@ .......... _ stop it.
*Screw the dipstick _ completely out, and
then just rest the dipstick in the hole.
NOTE:
Wake afew minutes until level settles before
checking.
*Pull up the dipstick, and inspect the oil level
whether or not it is between maximum @-}
50 40 50 60°F
and minimum level _3}.
__ *If the level is lower, add the oil up to the
,1, m@ proper level.
_} _" _ _ Recommended oil:
, _ At 5°C {40°F) or Higher @:
0 5 IO 15°C SAE 20W40 Type SE Motor Oil
At 15°C {60°F) or Lower _6_:
SAE 10W30 Type SE Motor Oil
ENGINE OIL REPLACEMENT
Engine Oil RepJacement {Without OiJ Filter)
1. Warm up the engine for several minutes, then
place a receptacle under the engine.
2. Remove:
*Side cover (Left)
Refer to "REMOVING THE COVERS AND
PANELS", page 2q3.
* Dipstick _}
*Drain bolt
Drain the engine oil completely.
3. Inspect:
*Gasket (Drain bolt) _3_
pl , Damage-+ Re ace.
4. Tighten:
[_ Drain Bomt: 1
43 Nm (4.3 mokg, 31 ft,lb)
2%