Yamaha XC200T Service Manual page 234

-] GENERAL TORQUE SPECIFICATIONS/
APPX
DEF|NITmON OF UN|TS
GENERAL TORQUE SPEC|FICA-
General torque
T iONS
A g
specifications
(Nut) (BoRt)
This chart specifies torque for standard fasteners Nm m,kg ft,lb
with standard t°S.O, pitch threads_ Torque specifi- 10 mm 6 mm 6 0.6 4.3
cations for special components or assemblies are 12 mm 8 mm 15 1,5 11
included in the applicable sections of this book. 14 mm 10 mm 30 3.0 22
To avoid warpage, tighten multi-fastener assem- 17 mm 12 mm 55 5.5 40
blies in a crisscross fashion, in progressive stages, 19 mm 14 mm 85 8,5 61
until full torque is reached. Unless otherwise 22 mm 16 mm 130 13,0
specified, torque specifications call for clean, dry
threads. Components should be at room tem_
perature,
A
A: Distance across flats
B: Outside thread diameter
DEFmN|T|ON OF UNmTS
Unit Read Definition Measure
mm millimeter 10- 3 meter Length
cm centimeter 10 z meter Length
kg kitogram 103 gram Weight
N Newton 1 kg x m/sac 2 Force
Nm Newton meter N × m Torque
m,kg Mater kilogram m x kg Torque
Pa Paskal N / m 2 Pressure
N/ram Newton per millimeter N/ram Spring rate
L Liter
-- Volume or Capacity
cm; Cubic centimeter
r/rain Rotation per minute -- Engine speed
a
7-.17