Oki OKIPAGE8c Maintenance Manual page 98

(d) Fuser count reset
Resets the fuser life after the fuser unit is replaced.
(e) Belt count reset
Resets the belt life after the belt unit is replaced.
(f) Oil roller count reset
Resets the oil roller life after the oil roller unit is replaced.
(g) Resource save area
Sets the resource saving area. This menu item appears when the option PS SIMM and
RAM increases, the selectable size will also increase (When adding a RAM over
24Mbytes, the selection can be made up to 22.5Mbytes). The size upon auto will also
increase if the size of the add-on RAM increases.
(h) Receive buffer
Sets the receive buffer. The data transmission time from the upper command will
decrease when set to a high value, but memory overflow will occur easier. Memory will
be restructured with this change, and the contents of all download fonts, PCL macro, and
PodtScript will be lost.
(i) Operator panel menu disable
Enables or disables the menu functions (Menu1, Menu2, Tray Type, Power Save, and
Paper Size) of the operator panel.
(j) X adjust
1 Corrects the position of the whole print image so that it may be perpendicular to the
movement of paper (at intervals of 0.25mm).
2 The print image exceeding the specified printable area is clipped.
(k) Y adjust
1 Corrects the position of the whole print image so that it may be parallel to the
movement of paper (at intervals of 0.25mm).
2 The print image exceeding the specified printable area is clipped.
(l) Darkness (Yellow, Magenta, Cyan and Black)
Sets the printout density of each color.
(m) SETTING
Used for fine adjustments in the case that operational environment, the use of special
paper, etc may produce a prominent blur and dispersion on the resulted pages. Executes
a PQ correction for continuous use of special environment and madia. When any
scattered printing or snow flake-like printing is output, it should be decremented. When
the printing becomes scratchy, it should be incremented. Press the ENTER key to write
the setting to the EEPROM.
(n) Color Register Adjust Execute
Sets values for correcting X-axis, diagonal, and Y-axis deviations of the LED heads
(yellow, magenta, and cyan) relative to black. The tandem-type page printer OKIPAGE
8c is equipped with an array of image drum (I/D) units which cannot be free from
generation of color deviations. The color deviations are main scanning, sub-scanning,
and diagonal deviations. These mechanically-caused color deviations are corrected
electronically.
4 - 2