Oki OKIPAGE8c Maintenance Manual page 118

Category LCD Status
Message
Daily status PRINT MENU Undefined
OIL ROLLER LIFE Undefined
Undefined
OIL ROLLER LIFE
PRINT FONTS Undefined
******* Blink
TONER EMPTY
WASTE TONER FULL Undefined
FRONT TRAY ERROR Undefined
PRESS
RECOVERKEY
COVER OPEN Undefined
BELT NOT Undefined
INSTALLED
LED
K C M
Undefined Undefined Undefined Blink or ON
Undefined Undefined Undefined
Undefined Undefined Undefined
Undefined Undefined Undefined Blink or ON
Blink Blink Blink
Undefined Undefined Undefined
Undefined Undefined Undefined
Undefined Undefined Undefined
Undefined Undefined Undefined
Y READY ATTENTION
Undefined Prints out a menu setting.
This operation is started by a command when the
READY LED is on or by a switch when the READY
LED is blinking.
Undefined ON Indicates that the life of the Oil roller assy has come.
(Warning)
OFF Blink Indicates that the life of the Oil roller assy has come.
(Alarm)
Undefined Prints out all character sets (fonts) that the page
printer contains.
This operation is started by a command when the
READY LED is on or by a switch when the READY
LED is blinking.
OFF Blink Displayed when 50 pages are printed after "Toner
Low" was detected to prompt the user to replace
the toner cartridge.
OFF Blink Displayed when 100 pages are printed after "Box
toner Assy Full" was detected to prompt the user to
replace the box toner Assy.
OFF Blink Indicates that the front feeder has caused a home
position error.
OFF Blink Indicates that the printer covers is open.
OFF Blink Indicates that the belt cassette Assy has not been
installed.
Trouble or Status
Normal operation
This massage is cleared when the oil
roller assy is replaced. After the oil roller
assy is replaced, its counter must be
reset. (See the user's manual)
Normal operation
This message temporarily disap-
pears when a cover of the page
printer is opened but will be dis-
played every 20 pages unless the
cartridge is replaced.
This error is reset when the box
toner Assy is replaced. Printing is
suppressed until it is replaced.
The front feeder becomes not avail-
able when the RECOVER switch is
pressed. The other tray is available.
This message is cleared when the
front feeder assembly is replaced.
This error is reset when the cover is
closed. If this error occurs fre-
quently, go to 6.5.2.
This error is recovered when the belt
cassette Assy is installed. Printing
is suppressed until the belt cassette
assembly is installed.
Remedy