Oki OKIPAGE8c Maintenance Manual page 123

Category LCD Status
Message
Controller ERROR Blink
Error nn
Undefined
Blink
Undefined
LED
K C M
Blink Blink Blink
Undefined Undefined Undefined
Blink Blink Blink
Undefined Undefined Undefined
Y READY ATTENTION
OFF Blink Code
(nn)
77
OFF Blink
80
82
OFF Blink
92
OFF Blink
D6
D7
D8
D9
DA
Trouble or Status
Details of error
Indicates that Toner sensor is
abnormal when page counter is
below thirty.(alarm)
Indicates that a timeout occurred Check the connection between the main
on interface between the page board and the operation panel. Turn on the
printer and the operator panel.
power of the page printer again. If this error
still occurs, replace the cable, the main board
(PCR PCB) or the cover assembly operation
panel.
When replacing the main board (PCR PCB),
demount the EEPROM chip from the old main
board and remount it on the new main board.
Check the connection between the main
Indicates that a timeout occurred
board and the engine board. Turn on the
on CU-PU interface.
power of the page printer again. If this error
still occurs, replace the program ROM of the
main board (PCR PCB) or the engine board
(PX4 PCB), or the board itself.
When replacing the main board (PCR PCB),
demount the EEPROM chip from the old main
board and remount it on the new main board.
See Chapter 6.5.2
Indicates that the printer overruns.
See Chapter 6.5.2
Yellow Image drum unit up/down
error
Magenta Image drum unit up/down
See Chapter 6.5.2
error
Cyan Image drum unit up/down
See Chapter 6.5.2
error
Black Image drum unit up/down
error
Environment temperature sensor Make sure that the surrounding temperature
error stays -10 < t< 50°C. If this condition is not
satisfied, adjust the surrounding temperature,
otherwise satisfied, replace the sensor board
(RXM-PCB), junction board (PXF-PCB) or
engine board (PX4-PCB).
Remedy
Remedy