Wolf Outdoor Grills Use & Care Manual page 10

Outdoor Grill Operation
Rotisserie System
The rotisserie system rotates food in front of an infrared
burner for even cooking and a more juicy taste. The two-
position rotisserie allows for food of different sizes to cook
at the proper distance from the infrared rotisserie burner.
The maximum load for the rotisserie is 25 lbs
LOW POSITION FOR LARGE LOADS
1) Install the rotisserie motor in the position shown in the
illustration below. The motor socket hole will line up
with the lower notch of the spit saddles.
2) Insert the rotisserie spit rod into the motor socket hole
and place rod on the lower notch of each spit saddle.
Remove the burner grates and place the basting pan
on top of the briquette trays to catch drippings.
HIGH POSITION FOR SMALL LOADS
1) Install the rotisserie motor in the position shown in the
illustration below. The motor socket hole will line up
with the upper notch of the spit saddles.
2) Insert the rotisserie spit rod into the motor socket hole
and place rod on the upper notch of each spit saddle.
Place the basting pan on top of the burner grates to
catch drippings.
For easy removal of the spit rod, lift slightly on the rotis-
serie motor and pull the spit rod out.
LOW POSITION
Low rotisserie position.
.
(11 kg)
HIGH POSITION
High rotisserie position.
USING THE ROTISSERIE
1) Install the rotisserie motor on the motor bracket and
plug it in to a GFCI 120 V AC electrical outlet.
2) Insert food in the middle of the spit rod and secure it
with the meat forks on both ends by tightening the
thumb screws. If multiple pieces of food will be cooked
at the same time, make sure the load is evenly
balanced on the spit rod.
3) Insert the spit rod in the rotisserie motor at the desired
cooking position. For large loads, you may need to
remove the burner grates and warming rack for extra
clearance.
4) Always use the basting pan beneath the food to catch
drippings and prevent them from falling on the burners
and briquette trays. For large loads, the burner grates
may be removed to allow basting pan to sit directly on
the briquettes.
5) Locate the rotisserie knob which is the second knob
from the left.
6) Push in and turn the knob counterclockwise to the
HI position. The rotisserie igniter is located on the rear
panel next to the rotisserie burner. Refer to the illustra-
tion on page 8. If the burner fails to light within five
seconds, turn knob to the OFF position, wait five
minutes and repeat.
7) Once lit, close hood until the rotisserie burner has
reached desired cooking temperature (approx 10
minutes). Then place spit rod with food into rotisserie
motor.
8) Once cooking is complete, shut off the rotisserie
burner and main gas valve.
IMPORTANT NOTE: The rotisserie igniter will remain on
during the entire cooking period.
10