Vision Fitness XF40 Owner's Manual page 12

Xf40 AssEmBLY STEp 4
PEDAL ARM BRACKET
XF40
FLAT WASHER (K)
SPRING WASHER (B)
BOLT (L)
FLAT WASHER (I)
WAVY WASHER (J)
A open hardware for step 4.
B slide 1 flat washer (i) and 1 wavy washer (J)
onto the lower link arm.
C slide the lower link arm into the pedal arm
bracket.
d Attach the lower link arm to the pedal arm
bracket using 1 flat washer (k), 1 spring
washer (b) and 1 bolt (l).
E Repeat steps B–d on other side.
22
HARdWARE fOR STEp 4:
LOWER HANDLEBAR
FLAT
NUT (O) WASHER (I)
27 mm
Qty: 2
SPRING WASHER (B)
FLAT WASHER (K)
FLAT
WASHER (K)
20 mm
Qty: 4
LOWER LINK ARM
noTE: If hardware is not installed
BOLT (N)
properly, elliptical could squeak or
METAL TEFLON WASHERS (M)
creak during use.
F Place 2 metal teflon washers (m) on either side of
the lower link arm before sliding lower link arm
into bottom of lower handlebar.
g while holding the metal teflon washers (m) in place,
slide the lower link arm into the base of the lower
link arm and insert 1 bolt (n) through the lower
handlebar.
secure joint using 1 flat washer (k), 1 spring
H
washer (b) and 1 nut (o).
I Repeat steps F–H on the other side.
Xf40 AssEmBLY STEp 5
WAVY
WASHER (J)
29 mm
Qty: 2
SPRING
BOLT (L)
WASHER (B)
20 mm
15 mm
Qty: 2 WATER BOTTLE HOLDER
Qty: 4
METAL TEFLON
PRE-INSTALLED BOLTS
WASHER (M)
29 mm
Qty: 4
CONSOLE MAST
BOLT (N)
NUT (O)
72 mm Qty: 2
Qty: 2
HARdWARE fOR STEp 5:
BOLT (P)
15 mm
Qty: 4
A open hardware for step 5.
Remove 2 pre-installed bolts from the
B
console mast.
Attach water bottle holder to the
C
console mast using 2 pre-installed
bolts.
Attach wheel cover to mid stabilizer
d
using 2 bolts (p). Repeat on other side.
BOLTS (P)
WHEEL COVER
MID STABILIZER
XF40
23