Wan Cable - Avaya IP Office Installation Manual

10.12.16 V.24 WAN Cable
This cable is used for connection an IP Office 37-way D-type WAN port to the V.24 WAN service providers equipment.
• Supply: This cable is not supplied with the control unit or WAN3 module. It must be ordered separately.
• SAP Code: 700213416
• Cable: 12-core screened cable. Each core is 7/0.203mm (24 AWG) tinned copper stranded wire, nominal capacitance
of 95pF/m, resistance of 92 ohms/km, screened with tinned copper braid, maximum working voltage of 440V rms and
a maximum current per core of 1A rms. The maximum core to core capacitance must not exceed 800pF.
• Maximum Length: 5m/16'5''. This is the maximum length that should be used if the above cable is replaced with an
alternate cable.
IP Office Installation
IP Office
IP Office Signal
WAN Port
6 Ground
8 DTR: Data Terminal Ready.
9 Rx: Receive Data
10 Tx: Transmit Clock
11 DCD: Data Carrier Detect.
12 CTS: Clear To Send.
26 Tx: Transmit Data.
27 RTS: Request To Send.
28 Rx-Clk: Receive Clock.
29 RI: Ring Indicator.
30 DSR: Data Set Ready.
• At the IP Office end pin 25 is connected to pin 6.
• At the IP Office end pin 19 is connected to the Screened Cable
Drain Wire.
V.24 WAN
Service
7
20
3
15
8
5
2
4
17
22
6
15-601042 Issue 20b (16 July 2009)
Page 364