Joyner JNSZ650DLB Owner's Manual And Parts Manual page 56

Step 2 finished
3) Install the shifter shaft ASSY finished above to transmission. (See Figure 74)
Bolt M10x1.5x20
Shifter shaft ASSY
Figure 74
B. Front Wheel Alignment
a) Put the vehicle on level ground.
b) The "toe-in" of the front wheels should be 1.18 inches. To check for alignment,
measure distance A and B between the centerline (CL) of the wheels. The proper
toe-in dimension A should be 1.18 inches greater than dimension B.
c) To adjust the alignments, loose the lock nuts on both sides of Front Tie Rods. To
make Dimension B smaller, turn the rod to the left. Turn the rod to the right to make
Dimension B larger. After adjusted to desired length, tighten the lock nut against the
rod end. Recheck the dimensions for proper alignment.