Attach Propeller Shaft And Shaft Carrier - Joyner JNSZ650DLB Owner's Manual And Parts Manual

Attach propeller shaft and shaft carrier

3
2
The right proppeller shaft
is longer than the left
3 02.D650.03.02.02
2 02.D650.03.02.03
1
02.D650.03.02.0001
1.Check the clip on the output shaft of transmission, confirm the clip is in the groove
on the output shaft of transmission.
2. Insert right proppeller shaft-2 onto the output shaft of transmission, confim the clip
on the output shaft clip in the groove .
3. Put 3# Lithium-grease on the seal area if necessary.
4. Insert other end of right proppeller shaft-2 into shaft carrier-1.
5. Insert bolt into the hole of hub and upper arm. Tighten the bolt and nut with thread glue.
6. Attach lower arm to the hub as above.
7. Tighten the nut-4 with thread glue.
8. Insert pin into the lock-hole on the proppeller shaft, and lock the pin-5.
9. Attach the brake hose to the lower suspension arm with clamp provided.
10. Attach the left side as figure .
Attach propeller shaft and shaft carrier
transmission
D650.03.02.02.00
D650.03.02.03.00
D650.03.02.00.01
Erp code code name
right drive shaft attaching
rear right suspension arm
same as page 4
1
left proppeller shaft
right proppeller shaft
shaft carrier
Description
4
5
1
1
2
Q'ty