Lexmark Optra T 4069 series Service Manual page 48

4069-XXX
User Error Message
56 Parallel Port Disabled
58 Too Many Trays
Attached
58 Too Many Bins
Attached
58 Too Many Disks
Installed
61 Defective Disk
62 Disk Full
63 Unformatted Disk
80 Scheduled
Maintenance
Explanation
This error is displayed when data is sent to the
printer across the parallel port, but the parallel
port has been disabled. Once this message is
displayed, reporting of further errors is
suppressed until the menus are entered, or the
printer is reset.
This error code is displayed when too many input
trays are attached to the printer.
This error code is displayed when too many
optional output bins are attached to the printer.
This error is displayed when too many disks are
attached to the printer.
This error code is displayed when the printer
detects a defective disk. This error may occur at
power on or during disk format and write
operations. The following actions may be taken
while this message is displayed: Press Go to
clear the message. The disk is marked defective
and normal printer operations continue. Disk
operations are not allowed with a defective disk.
The Format Disk menu is not shown.
This error code is displayed when there is not
enough free space on the disk to hold the
resources that have been requested to be written
to the disk. This message displays for both
resource and PostScript Disk operators when the
disk is full.
This error code displays when the printer detects
an unformatted disk at power on. Press Go to
clear the message. The disk is marked as bad
and normal operation continues. Disk operations
are not allowed until the disk is formatted.
The operator panel displays this message at each
300K page count interval. It is necessary to
replace the fuser assembly, transfer roller, and
charge roll at this interval to maintain the print
quality and reliability of the printer. The parts are
available as a maintenance kit. For more
information, go to
page 6-2.
"Scheduled Maintenance" on
Diagnostic Information
2-19