Clear The Spray Tip - WAGNER PROCOAT MAX Owner's Manual

Spraying
Troubleshooting -
Clear the
Spray Tip
Start
You will need:
• Scrap material / cardboard
Do not attempt to unclog or
clean the tip with your finger.
High pressure fluid can cause
injection injury.
English
1
1. Lock the spray gun.
3
3. Make sure the PRIME/SPRAY
knob is turned to SPRAY -
MINIMUM PRESSURE.
Unlock the spray gun.
2
2. Rotate reversible spray tip 180 degrees
to ClEan position (arrow pointing
toward the rear of the spray gun).
4
4. Point at a piece of scrap material / card-
board and squeeze trigger until material
comes out in a high pressure stream.
Release the trigger and lock the spray
gun.
12
note: If spray tip is difficult
to rotate, relieve pressure
by 1) slowly turn PRIME/
SPRAY knob to PRIME, 2)
unlock the spray gun and
3) squeeze trigger while
pointing at scrap material/
cardboard. Release
trigger, lock the spray gun,
and try rotating spray tip
again.
5
5. Reverse the spray tip so
the arrow points forward.
Unlock the spray gun and
resume spraying.