Advertisement
Available languages
Available languages
Locking and Unlocking the Spray Gun
Locking the gun
The gun is secured when the
trigger lock is at a 90° angle
(perpendicular) to the trigger in
either direction.
Unlocking the gun
To unlock the gun, turn the
trigger lock to be in line with the
trigger.
Attaching the Tip Assembly
1. Thread the spray guard assembly onto the gun. Tighten by hand.
Begin
tightening
the tip at
this angle
Unclogging the Spray Tip
WARNING
Do not attempt to unclog or clean the tip with your finger. Do not use a
needle or other sharp pointed instrument to clean the tip. The hard
tungsten carbide is brittle and can be chipped.
The spray gun is equipped with a reversible tip which allows you to blow
out any particles of old paint or other contaminants that may obstruct
the paint flow through the tip. If the spray pattern becomes distorted or
stops completely while the gun is triggered, follow these steps:
1. Follow Pressure Relief Procedure (see sprayer instruction manual)
2. Rotate the reversible tip cylinder arrow 180°
so that the point of the arrow is toward the
rear of the gun.
3. Unlock the gun and squeeze the trigger,
pointing the gun at a scrap piece of wood or
cardboard. This allows pressure in the spray
hose to blow out the obstruction. When the
nozzle is clear, paint will come out in a straight, high pressure stream.
4. Release the trigger and lock the gun off.
5. Reverse the tip so the arrow points forward again.
6. Unlock the gun and resume spraying.
Cleaning the Gun
NOTE - If spraying with latex paint, use warm soapy water for cleaning.
If using oil or alkyd-based paints, use mineral spirits or paint thinner.
Refer to the paint manufacturer's instructions for specific
recomendations.
Do not use mineral spirits or paint thinner on latex paint, or the mixture
will turn into a jellylike substance which is difficult to remove.
1. Check that the spray tip assembly has been removed from the gun.
2. Run the appropriate solvent through the pump.
3. Hold the metal part of the gun against a metal
container to ground the gun.
4. Trigger the gun into the container until it is flushed
clean. Use the lowest possible pressure.
to achieve
the desired
spray angle
when tight.
Cleaning the Filter
This filter must be cleaned every time you use your sprayer.
When using thicker paints, the filter might need to be cleaned
more often.
Part No.
Tip Size
0154675
413 - 415
1. Unclip the trigger guard from the filter housing by pulling outward from
the filter housing. Unscrew the housing.
Filter
Trigger
guard
2. Remove the filter from the spray gun housing and clean with the
appropriate cleaning solution (warm, soapy water for latex paints,
mineral spirits for oil-based materials).
3. Inspect the filter for holes (see Hole picture, above). Replace if holes
are found.
NOTE - NEVER POKE THE FILTER WITH A SHARP INSTRUMENT!
4. Replace the cleaned filter, tapered end first, into the gun housing.
5. Replace the housing and spring and snap the trigger guard back into the
housing.
Parts List
3
1
2
Item
Part #
Description
1
0501011
Guard Assembly ....................................................1
2
0501415
Tip, 415..................................................................1
3
0515229
Complete gun assembly........................................1
4
0154675
Filter, yellow*
5
0515332
Seal .......................................................................1
6
0515329
Filter housing.........................................................1
*2-pack replacement kit
© 2006 Wagner Spray Tech, 1770 Fernbrook Lane, Plymouth, MN 55447 - All Rights Reserved.
Filter
Mesh
Color of
Filter
Type
Number
Body
Fine
100 mesh
yellow
0.140 mm
Filter top
(tapered
end)
Hole
Housing
5
6
4
Quantity
Advertisement
