Saving The Present Configuration - Fluke 867B User Manual

"Load Screen" appears when you select one of the
three screens. Press 4 to display the stored
waveform along with the active waveform. The GMM
assumes the time base and amplitude settings of the
stored waveform. With the recalled and active
waveforms both displayed, you can press P to
access the following three softkeys: 3 "Print" to
the two-waveform display; 4 "Clear Exit" to clear
the recalled waveform and return to the active
waveform display; 5 "Exit" to return to the two-
waveform display.
If you press any other key, the recalled waveform
clears and the display returns to the active
waveform.
In View Mode, the stored waveform must have been
saved while the GMM was in View Mode. The loaded
screen appears as solid lines. In COMPONENT
TEST, the stored memory must have been saved
while the GMM was in COMPONENT TEST.
5 (Exit) returns to the Print/Save softkeys
(display frozen).
Using Save, Recall, Print, and Set Up

Saving the Present Configuration

Saving the Present Configuration
Save >
Config.
] [
Save
1 and 2 select the Memory location.
3 (Save) stores present configuration and
numerical data sufficient to recreate this display. A
message appears while the configuration is being
saved. The GMM test tool then returns to the
Save/Print display.
4 (Clear) clears this memory location. ("Clear"
appears only if something has been saved in this
memory location.)
5 (Exit) returns to the Save/Print display.
6
Clear Exit
6-5