Fluke 867B User Manual page 17

867B/863
Users Manual
STEP ACTION
d
CHANGE THE DISPLAY MODE
1
With the GMM still in AC Volts, press first d, then 3 to change the display mode. The
screen changes to the View Mode, where the entire screen is used for displaying a waveform.
You can repeat this procedure to select any of the display modes available in AC Volts (Combo,
Meter, View, and Trend.) Refer to Table 1-3 for an overview of display modes available in each
function. Examples of all display modes (Combo, Meter, View, Trend, Logic Test, Auto Diode
Test, Component Test, and Sleep) follow this table. Along with the flexibility provided by multiple
softkey definitions, display modes increase the versatility of your GMM considerably.
Many operations activated in one display mode are retained when you select a new mode. For
example, "Rel", "dB", Min Max, range, and frequency measurement type are retained.
J
CHANGE THE FUNCTION
2
Rotate the selector to DC Volts (E). Observe that the display shifts back to Combo Display Mode.
(This is the default mode, as established on the screen you see when you turn the selector to
SET UP.)
1
USE THE SOFTKEYS
3
With DC Volts and Combo Mode still active, you can use the DC Volts Softkeys. For example,
press 1 to activate "Rel": difference readings only are now displayed. Press 1 again to
deactivate "Rel". Explore all five softkeys in this fashion. Press a key first to activate a selection
(label highlighted) and second to disable the selection.
1-6
Table 1-2. A Practice Session
DESCRIPTION