Inflating
›
Screw the tyre inflation hose
5
firmly onto the tyre valve.
›
Check that the air release valve
›
Start the engine and run it in idle.
›
Plug the connector
9
into 12 Volt socket
›
Switch on the air compressor with the ON and OFF switch
›
Allow the air compressor to run until a pressure of 2.0 - 2.5 bar is achieved.
Maximum run time of 8 minutes
»
›
Switch off the air compressor.
›
If you cannot reach an air pressure of 2.0 – 2.5 bar, unscrew the tyre inflation
hose
from the tyre valve.
5
›
Drive the vehicle 10 metres forwards or backwards to allow the sealing agent to
"distribute" in the tyre.
›
Firmly screw the tyre inflation hose
inflation process.
›
If you cannot reach the required tyre inflation pressure here either, this means
the tyre has sustained too much damage. You cannot seal with tyre with the
breakdown kit
»
.
›
Switch off the air compressor.
›
Remove the tyre inflation hose
5
Once a tyre inflation pressure of 2.0 – 2.5 bar is achieved, continue the journey at
a maximum speed of 80 km/h (50 mph).
Check the tyre inflation pressure after driving for 10 minutes
WARNING
During inflation, the tyre inflation hose and air compressor may get hot- risk
■
of injury!
Do not place the hot tyre inflation hose or hot air compressor on flammable
■
materials – risk of fire!
If you cannot inflate the tyre to at least 2.0 bar, this means the damage sus-
■
tained was too serious. The sealing agent cannot be used to seal the tyre.
Do not drive the vehicle. Get professional assistance!
CAUTION
Switch off the air compressor after running 8 minutes at the latest – danger of
overheating! Allow the air compressor to cool a few minutes before switching it
on again.
134
Do-it-yourself
» Fig. 115
on page 133 of the air compressor
is closed.
7
» page
46, 12-volt power socket.
.
8
!
back onto the tyre valve and repeat the
5
from the tyre valve.
» page
134.
Check after driving for 10 minutes
ä
First read and observe the introductory information and safety warn-
ings
on page 132.
Check the tyre inflation pressure after driving for 10 minutes!
If the tyre inflation pressure is 1.3 bar or less:
›
Do not drive the vehicle! You cannot properly seal with tyre with the break-
down kit.
›
Get professional assistance.
If the tyre inflation pressure is 1.3 bar or more:
›
Adjust the tyre inflation pressure to the correct value (see inside of fuel filler
cap).
›
Continue driving carefully to the nearest ŠKODA specialist garage at a maxi-
mum speed of 80 km/h (50 mph).
Jump-starting
ä
Introduction
This chapter contains information on the following subjects:
Jump-starting
Jump-starting in vehicles with the START-STOP system
The battery of another vehicle can be used to jump-start your vehicle if the en-
gine will not start because the battery is flat. Jump-start cables are required for
this purpose.
Both batteries must have a rated voltage of 12 V. The capacity (Ah) of the battery
supplying the power must not be significantly less than the capacity of the dis-
charged battery in your vehicle.
Jump-start cables
Only use jump-start cables which have an adequately large cross-section and in-
sulated terminal clamps. Observe the manufacturer's instructions.
Positive cable – colour coding in the majority of cases is red.
Negative cable – colour coding in the majority of cases is black.
Ð
Ð
135
136
£