Skoda 2012 Citigo Owner's Manual page 33

Hide thumbs Also See for 2012 Citigo:
Table of Contents

Advertisement

Settings
The positions correspond approximately to the following car load.
Front seats occupied, luggage compartment empty.
-
All seats occupied, luggage compartment empty.
1
All seats occupied, luggage compartment loaded.
2
Driver seat occupied, luggage compartment loaded.
3
CAUTION
Always adjust the headlight range adjustment in such a way that:
it does not dazzle other road users, especially oncoming traffic;
and the range is sufficient for safe driving.
Note
We recommend you adjust the headlight beam when the low beam is switched
on.
Switches for the hazard warning light system
ä
First read and observe the introductory information and safety warn-
ings
on page 29.
Press switch 
» Fig. 24
to switch the hazard warning light system on or off.
All the turn signal lights on the vehicle flash at the same time when the hazard
warning light system is switched on. The warning light for the turn signals and
the warning light in the switch also flash at the same time. The hazard warning
light system can also be operated if the ignition is switched off.
Fig. 24
Dash panel: Switch for hazard
warning lights
The hazard warning light system is switched on automatically if an airbag is de-
ployed in the event of an accident.
Note
The hazard warning light system must be switched on if, for example:
you encounter a traffic congestion;
your vehicle breaks down or an emergency situation occurs.
Turn signal and main beam lever
Ð
ä
First read and observe the introductory information and safety warn-
ings
on page 29.
The parking light and headlight flasher are also operated with the turn signal and
main beam lever.
Right
and left
turn signal light
Push the lever
» Fig. 25
upwards
If you only wish to flash three times (the "convenience turn signal"), briefly
push the lever to the upper or lower pressure point and release again.
Turn signal for changing lanes – to only flash briefly, move the lever up or down
to the pressure point and hold it in this position.
Main beam
Switch on the low beam
» page
Press the lever
» Fig. 25
in the direction of arrow
The main beam is switched off by pulling the lever into the initial position in the
direction of arrow
.
D
Fig. 25
Turn signal and main beam lever
or downwards
.
A
B
29.
.
C
Lights and visibility
Ð
£
31

Advertisement

Table of Contents
loading

Table of Contents