Receptacle Panel - Carrier ComfortPro PC6000 Operation & Service Manual

3.7 RECEPTACLE PANEL

SYMPTOM
No 120 VAC power
3-12
Each symptom is followed by a probable cause and suggested solution. To isolate the
possible cause, proceed in a systematic manner to determine the faulty component. This
guide does not cover all possible situations that may occur under all conditions of operation.
PROBABLE CAUSE
• High Heat Mode is selected
• APU not running
• 35 Amp breaker tripped at
generator
Disconnect the batteries from the
APU before performing any repairs.
SOLUTION
• Switch to 'Low Heat' position
• Start APU
• See "Generator" Section
62-11175 COMFORTPRO SERVICE MANUAL
WARNING
REFERENCE
• 1- 4, 1- 8
• 1- 4, 1- 8
• 3-6