Setting The Clock; Comfort Monitor - Carrier ComfortPro PC6000 Operation & Service Manual

NOTICE
The clock does not automatically
adjust for time zone changes; you
must adjust it.
62-11175 COMFORTPRO SERVICE MANUAL

1.3.3 Setting the Clock

You can set the clock on the DCP. This clock is used by the Timer function
(page 1-8). If you use the Timer function, remember that as you move from
one time zone to another, you must adjust the clock. Otherwise the Timer
will start the APU at the wrong time.
The clock settings remain even when the APU is turned off.
1 Press
.
2 Press or
is displayed, then press
If "ENTER PASSWORD" is displayed,
enter your password. If you do not
know the password, then you cannot
set up this function (see page 1-5).
The clock function takes you through
several settings: 12/24-hour-clock,
hour set, minutes set, am/pm-set (for
12-hour clock only), and day of the week.
3 Press or
4 Press to move to the next setting. Or press
changes you have not yet accepted.
5 When done, press

1.3.4 Comfort Monitor

You can specify the temperature you want in the truck bunk. Whenever the
truck bunk temperature goes 2° above or below this temperature, the APU
starts and the HVAC turns on until that temperature is reached or for
fifteen minutes, whichever is longer.
Turning COMFORT Monitor ON and OFF
1 Press .
2 Press or
"COMFORT MONITOR" is displayed,
then press .
If "ENTER PASSWORD" is displayed,
enter your password. If you do not
know the password, then you cannot set up this function (see page 1-5).
3 Press or
4 Press to confirm this setting.
The current setting remains until you change it; turning off the APU or
manually starting the APU does not permanently cancel this setting.
until "CLOCK"
HOURS
00000
.
HOURS
00000
CLOCK: SET MODE
to change the setting.
to exit.
HOURS
until
00000
COMFORT MONITOR:
to display "ON" or "OFF".
APU
CLOCK
APU OFF
OFF
12 HOUR
to cancel any
APU
ON
1-7