Battery Monitoring - Carrier ComfortPro PC6000 Operation & Service Manual

NOTICE
Factory Default Voltage Setting is 11.8V.
Range is 11.0V to 13.5V.
1-12

1.3.8 Battery Monitoring

You can set up the APU so that it automatically runs for 90 minutes when
the truck batteries are low.
When you set up this feature, you must enter the current voltage of the
batteries (see "Set the Initial Voltage"). The ComfortPro can then calculate
how much the voltage drops, as the batteries are used.
Set the INITIAL VOLTAGE
1. Press .
2 Press or
"CALIBRATE VOLTAGE" is displayed,
then press .
If "ENTER PASSWORD" is displayed, enter your password. If you do not
know the password, then you cannot set up this function (see page 1-5).
3 Press or
4 Press to confirm this setting.
Turning BATTERY MONITORING ON and OFF
1 Press .
2 Press or
"BATTERY MONITOR" is displayed,
then press .
If "ENTER PASSWORD" is displayed, enter your password. If you do not
know the password, then you cannot set up this function (see page 1-5).
3 Press or
4 Press to confirm this setting.
The current setting remains until you change it; turning off the APU or
manually starting the APU does not permanently cancel this setting.
The APU starts if the battery voltage goes below the level you specify here.
Setting the Voltage Level
1 Press .
2 Press or
"BATTERY MONITOR" is displayed,
then press .
If "ENTER PASSWORD" is displayed, enter your password. If you do not
know the password, then you cannot set up this function (see page 1-5).
3 Press or
4 Press to confirm this setting. The current voltage level is
MENU
displayed and flashes.
5 Press or
6 Press to confirm this setting. Or press
retain the current voltage.
7 Press to exit.
HOURS
00000
CALIBRATE
until
to set the current voltage of the batteries.
HOURS
00000
until
BATTERY MONITOR
to display "ON" or "OFF".
HOURS
00000
BATTERY MONITOR : SET
until
to display "SET".
to scroll to the desired voltage.
62-11175 COMFORTPRO SERVICE MANUAL
APU
OFF OFF
VOLTAGE
APU
OFF OFF
ON
APU
OFF OFF
11.8 V
to cancel and