Registering Addresses Obtained Via An Ldap Server; Registering In The Address Book - Canon imageRUNNER 1750i Facsimile Manual

5
NOTE
• To cancel a selected destination, select the destination again to clear the check mark.
• If the optional Super G3 Fax Board-AJ1 is attached to the machine, you can sort and
limit the view of the displayed addresses by using the Type drop-down list.
• The destinations you can specify may vary depending on the settings under <Send
Restriction Settings>. (See Chapter 4, "Customizing Settings," in the Remote UI
Guide.) For example, if E-mail Send is set to 'Do not allow' or 'Only allow sending to
own address', e-mail addresses are not displayed as the search results.
• If a fax number or I-fax address is specified as the destination, read the displayed
message ➞ press [OK].

Registering Addresses Obtained via an LDAP Server

Follow this procedure to register the destinations that are obtained by searching the
directory listings on the network using LDAP (Lightweight Directory Access
Protocol) servers.

Registering in the Address Book

1
Display the Register Address screen ➞ press [Register New Add].
For help, see steps 1 and 2 in "E-Mail Addresses," on p. 4-3.
Select the desired destination
from the search results ➞ press
[OK].
You can select up to 32 destinations.
If you press [Select e-mail for I-Fax], the
selected e-mail address can be specified
as an I-fax destination.
To continue searching, press [Back].
LDAP Server
4
4-61