Canon imageRUNNER 1750i Facsimile Manual page 285

# 0755
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
# 0801
Cause 1
Remedy
Cause 2
9
Remedy
Cause 3
Remedy
# 0802
Cause 1
Remedy
Cause 2
Remedy
9-16
Self-diagnostic Display
Jobs cannot be sent because TCP/IP is not functioning correctly.
Check that TCP/IP Settings in Network Settings is set correctly. (See Chapter 2,
"Connecting the Machine to a TCP/IP Network," in the System Settings Guide.)
The IP address is not set.
Check that TCP/IP Settings in Network Settings is set correctly. (See Chapter 2,
"Connecting the Machine to a TCP/IP Network," in the System Settings Guide.)
When the machine was turned ON, an IP address was not assigned to the
machine by the DHCP, RARP, or BOOTP server.
After the machine is turned ON, communication with a network will not start until
the time specified in Startup Time Settings in Network Settings elapses. (See
Chapter 7, "Other System Settings," in the System Settings Guide.) Wait a few
moments, and then try sending again.
A timeout error occurred while the machine was communicating with the SMTP
server to send an e-mail or send/receive an I-fax.
Check that the SMTP server is functioning normally, or check the network
status.
The SMTP server returned an error while trying to connect. The destination is
not correct.
Check the destination setting.
An error occurred on the server side during transmission to a file server.
Check that the file server is functioning normally.
The name of the SMTP server is incorrect.
Check that SMTP Server in E-mail/I-Fax is set correctly. (See Chapter 3,
"Setting up the Machine for Your Network Environment," in the System Settings
Guide.)
The DNS server address settings are incorrect.
Check that Primary DNS Server and Secondary DNS Server in DNS Server
Address Settings are set correctly. (See Chapter 3, "Setting up the Machine for
Your Network Environment," in the System Settings Guide.)