Panasonic WV-SC386 Installation Manual page 19

• 12 V DC power supply terminal
q Loosen the screw of the power cable plug (accesso-
ry).
w Connect the output cable to the power cable plug.
Strip 3 mm to 7 mm {1/8 inches to 9/32 inches} from
the end of the wire, and twist the stripped part of the
wire sufficiently to avoid short circuit.
Specification of cable (wire): 16 AWG - 24 AWG,
* Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cable plug.
r Connect the power cable plug to the 12 V DC power
supply terminal on the rear of the camera.
* FOR UL LISTED MODEL(S), ONLY CONNECT 12 V
DC CLASS 2 POWER SUPPLY.
–
Power cable plug
(accessory)
IMPORTANT:
• The 12 V DC power supply shall be insulated from the
commercial AC power.
• Be sure to use the power cable plug provided with
this product.
• Be sure to fully insert the power cable plug into the
12 V DC power supply terminal. Otherwise, it may
damage the camera or cause malfunction.
• Be sure to use an AC adaptor compliant with the
Specifications regarding power source and power
consumption (☞ page 31).
Single core, twisted
Strip range
Approx. 3 mm - 7 mm
{1/8 inches - 9/32 inches}
+
Step 9
After completing the cable connections, attach the deco-
rative cover (accessory).
q Separate the provided decorative cover into 2 pieces.
• Release the stoppers by pressing the decorative
cover in the direction of the arrows on the side
decorative cover.
Release both stoppers.
Rear view
Release the
stoppers
Hold securely and
disengage them.
IMPORTANT:
• When pressing to the reverse direction, it may damage
the decorative cover.
w Attach the decorative cover to the camera.
• Position the pieces of the decorative cover that have
been split in step 9 to tuck down the camera body,
and then attach them together.
Attach the decorative cover by aligning the direction
of the Panasonic logo and the cut out parts.
Push up the decorative cover as shown in the
illustration.
Hold one of 2 pieces securely
and engage them.
Push
Push
Align the direction of the Panasonic logo and the cut out part.
* If the directions are not aligned, the decorative cover make come off.
Hold securely and
disengage them.
Rear view
Attach the
stoppers
19