Panasonic WV-SC386 Installation Manual page 18

Lock plate
Guide part
Main body
of the
camera
IMPORTANT:
• When mounting the camera onto the camera mount
bracket, hold the main body of the camera. Mounting
the camera while holding the dome cover may result
in malfunction.
Step 7
Fix the camera on the camera mount bracket (accessory)
using the camera fixing screw (M3, accessory).
Recommended tightening torque: 0.68 N·m {0.50 lbf·ft}
Fixing screw
(M3, accessory)
18
Center of the
camera mount bracket
Camera mount bracket
(accessory)
Step 8
Connect the cables to the network connector and the
power inlet.
IMPORTANT:
• Do not touch the camera in the process of initializa-
tion. Otherwise, it may fail to initialize and may cause
malfunction.
Network connector
12 V DC power supply terminal
• Network connector
Connect a LAN cable (category 5 or better, STP*) to the
network connector.
* E model only
IMPORTANT:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m {328 feet}.
• Make sure that the PoE device in use is compliant
with IEEE802.3af standard.
• When connecting both the 12 V DC power supply
and the PoE device for power supply, 12 V DC will be
used for power supply.
• When the LAN cable is disconnected once, reconnect
the cable after around 2 seconds. When the cable is
quickly reconnected, the power may not be supplied
from the PoE device.