Panasonic WV-SC386 Installation Manual page 16

Wire through a hole in the ceiling
Step 1
Fix the camera mount bracket (accessory) with four
optional fixing screws (M4, option).
There should be no obstacles such as wall in a range of
100 mm {3-15/16 inches} away from the center point of
the camera mount bracket.
Shooting direction (FRONT)
{3-9/32 inches}
Step 2
Make a hole in the ceiling to pass the cables through.
Make a hole 25 mm {31/32 inches} in diameter. The cen-
ter point of the hole should be located approx. 75 mm
{2-15/16 inches} away from the center point of the cam-
era mount bracket.
Wiring hole
(ø25 mm {31/32 inches})
16
83.5 mm
100 mm {3-15/16 inches} or more
away from obstacles such as wall
Step 3
Insert the SDHC/SD memory card into the SDHC/SD
memory card slot. Refer to page 23 for how to insert the
SDHC/SD memory card.
Step 4
Attach the safety wire fixed with the camera mount
bracket (accessory) to the camera.
After attaching the safety wire to the camera, confirm that
the ring part at the end of the safety wire is securely
hooked on the safety wire holder.
Step 5
Connect cables to the External I/O terminals, microphone/
line input connector, audio output connector and the
monitor out connector for adjustment. When connecting
these cables, hold the main body of the camera.
Microphone/line
input connector
External I/O terminals
Main
body
• External I/O terminals
Connect external devices.
When connecting an external device, remove 9 mm -
10 mm {11/32 inches - 13/32 inches} of the outer jacket
of the cable and twist the cable core to prevent the short
circuit first.
Safety wire
Safety wire holder
Audio output connector
Monitor out
connector for
adjustment