Rear View - Panasonic WV-SC386 Installation Manual

<Rear view>
Access indicator
(blinks when accessing)
Network connector
About the [INITIAL SET] button
After turning off the power of the camera, turn on the power of the camera while holding down this button, and wait for
around 5 seconds or more without releasing this button. Wait around 3 minute after releasing the button. The camera will
start up and the settings including the network settings will be initialized. Before initializing the settings, it is recommended
to write down the settings in advance. The initialization will be complete when the live indicator stops blinking orange and
lights off. Note that the preset position settings and the CRT key (SSL encryption key) used for the HTTPS protocol will not
be initialized.
IMPORTANT:
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may fail to initialize and may
cause malfunction.
14
12 V DC power supply terminal
Link indicator
(lit when linking)
External I/O terminals
Monitor out connector
for adjustment
Safety wire holder
Audio output connector
Microphone/line input connector