Avaya 1140E Install Manual page 39

Method A:
1. Press the wall-mount lever, and pull the IP Deskphone away from the stand,
as shown in Figure
2. Use the stand cover (the part you removed in
mark the wall-mount holes by pressing the bottom of the stand cover firmly
against the wall in the location where you wish to install the IP Deskphone.
Four small pins on the bottom of the stand cover make marks on the wall.
3. Use the marks as a guideline for installing the wall-mount screws (not
provided). Install the screws so that they protrude 3 millimeters (mm) (1/8
inch) from the wall.
4. Install the IP Deskphone stand mounting holes over the screw heads as
indicated in Figure 10
from the wall to adjust the lower screws.
5. When the lower screws are snug, install the IP Deskphone on the
mounting screws, and then tighten the top screws.
Figure 11: Rotate the IP Deskphone into the wall mount position.
11.
(Method A). You need to remove the IP Deskphone
Using your IP Deskphone
"Removing the stand cover"), to