Subaru LEGACY 2004 Service Manual page 43

4) Place the ST B on bushing, and press-fit until
each edge surface of bushing and rear arm comes
to be aligned.
ST A 20099AE020 INSTALLER & REMOVER
SET
ST B 20099AE020 INSTALLER & REMOVER
SET
(2)
(1)
ST-B
ST-A
(1) 0±5°
(2) Identification paint: Assemble with the
identification paint side faced to the arm
inner side.
2. REAR BUSHING
1) Press the bushing into the bore inside of ST D.
2) Set the ST C, ST D and bearing puller in the
specified position as shown in the figure, and then
press-fit the bush until the outer end of bush and
rear end of rear arm in flat.
ST C 20099AE040 INSTALLER & REMOVER
SET
ST D 20099AE040 INSTALLER & REMOVER
SET
ST-C
Rear Arm
RS-00120
ST-D
RS-00056
E: INSPECTION
Check the rear arm for bend, corrosion or damage.
RS-13
REAR SUSPENSION