Subaru LEGACY 2004 Service Manual page 42

REAR SUSPENSION
8) Using the transmission jack, support the rear
arm horizontally.
9) Tighten the nuts and bolts which hold the rear
arm, front link, rear link, upper link and shock ab-
sorber.
NOTE:
Always tighten the bushing in the state that wheels
are in full contact with the ground and the vehicle is
curb weight.
(1)
(1) Rear arm
(2) Transmission jack
10) Install the sub frame support arm.
NOTE:
Inspect the wheel alignment and adjust it if neces-
sary.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion" for tightening torque. <Ref. to RS-3,
REAR SUSPENSION, COMPONENT, General
Description.>
C: DISASSEMBLY
1. FRONT BUSHING
1) Set the ST A with the larger side of its inner di-
ameter turned upward.
2) Set the rear arm with the protruding side of bush-
ing turned upward.
Rear Arm
(2)
RS-00052
3) Place the ST B on bushing, and push the bush-
ing out.
ST A 20099AE020 INSTALLER & REMOVER
ST B 20099AE020 INSTALLER & REMOVER
ST-B
ST-A
(1) Bushing
2. REAR BUSHING
Using the ST C and bearing puller, press the rear
bushing out of place.
ST C 20099AE040 INSTALLER & REMOVER
(1)
(1) Bearing puller
D: ASSEMBLY
1. FRONT BUSHING
1) Set the ST A with the larger side of its inner di-
ameter turned upward.
2) Set the rear arm with the vehicle inner side of
arm turned downward.
3) Place the bushing on rear arm as shown in the
figure.
RS-12
SET
SET
(1)
RS-00119
SET
ST-C
RS-00054