Subaru LEGACY 2004 Service Manual page 124

DIFFERENTIALS
ST1 498077000 REMOVER
ST2 399520105 SEAT
ST3 899864100 REMOVER
ST3
10) Remove the hypoid driven gear by loosening
hypoid driven gear bolts.
11) Support the companion flange with ST and re-
move self-locking nut.
ST 498427200 FLANGE WRENCH
ST
12) Extract the companion flange with a puller.
(A)
(A) Companion flange
(B) Puller
Rear Differential (VA-type)
ST1
ST2
DI-00370
DI-00371
DI-00372
(B)
DI-00394
13) Removes the drive pinion shaft.
14) Remove the rear bearing cone from drive pin-
ion by supporting cone with ST.
NOTE:
Place the replacer so that its center-recessed side
faces the pinion gear.
ST 398517700
15) Remove the front oil seal from differential carri-
er using screwdriver.
16) Remove the pilot bearing, front bearing cone
and collar.
(A) Pilot bearing
(B) Collar
(C) Front bearing
(D) Rear bearing cup
17) When replacing the bearings, hit out the front
bearing cup and rear bearing cup in this order out of
case by using a brass bar.
(B)
(A) 2 cutouts along diagonal lines
(B) Hit out alternately with brass bar
DI-54
REPLACER
ST
DI-00373
(D)
(B)
(C) (A)
DI-00374
(A)
DI-00077