Subaru LEGACY 2004 Service Manual page 123

5) Remove the holder RH and LH with ST.
ST 18630AA010 WRENCH
ST
6) Pull out the differential case assembly from dif-
ferential carrier.
NOTE:
Be careful not to hit the teeth against the case.
7) Remove the bearing race from holder RH and
LH with ST1 and press.
ST 18758AA000 PULLER
NOTE:
• Make sure the bolt of puller turn manually.
Rear Differential (VA-type)
• Set the puller so that its claws catch the groove of
holder.
DI-00365
DI-00366
8) Remove the oil seal from holder RH and LH us-
ing screwdriver.
NOTE:
Perform this operation only when changing oil seal.
9) Extract the bearing cone with ST1, ST2 and
ST3.
NOTE:
• Do not attempt to disassemble the parts unless
necessary.
• Never mix up the bearing races RH and LH and
cones.
DI-53
ST
(A) Groove
(B) Claw
(A) Holder
DIFFERENTIALS
ST
(A)
(B)
DI-00367
(A)
ST
DI-00368
DI-00369