Chapter 3 Troubleshooting; Led Blinking Pattern; Error Types - Epson TM-P60 Technical Reference Manual

Chapter 3
Troubleshooting
This section describes general troubleshooting.

3.1 LED Blinking Pattern

3.1.1 Error Types

The printer stops all printer operations, goes offline, and the ERROR LED blinks when an error
is detected.
ERROR
Printer temperature
error (*1)
Paper error
(Sa=0)
Layout error
Circuit error
Memory error
Voltage error
Software error
The radio unit error
Overload error
Battery charging error
Rev. B
Description
The internal temperature
of the printer is extremely
high
The basic position on the
label cannot be detected
Paper layout differs from
the actual paper
Paper jam occurs
The circuit board doesn't
work
The printer does not work
correctly in R/W checking.
The power supply voltage
is extremely high or low
The firmware does not
work correctly.
The IEEE802.11b radio
interface unit doesn't
work.
Temperature of thermal
head is abnormally high.
Temperature of
IEEE802.11b wireless
interface communication
unit is abnormally high.
Battery voltage does not
reach the prescribed
voltage.
Battery charging is not
performed.
TM-P60 with Peeler Technical Reference Guide
ERROR LED Blinking Pattern
320 ms
Recovery
Recovers automatically
when the printer cools
Recovers automatically
when the cover is
opened
Recovers by error
recovery command
Impossible to recover
Impossible to recover
Impossible to recover
Impossible to recover.
Impossible to recover
Impossible to recover
Replace the battery
Troubleshooting 3-1