Memory Switches - Epson TM-P60 Technical Reference Manual

Memory Switches

This printer has a set of software switches called "Memory switches." The memory switch set
has "Msw 8," "Customize value," "Serial communication condition."
The "Memory switch setting utility" can change the Memory switch set to ON or OFF as shown
in the table below:
Note:
When you use this printer with RS-232C interface, you should adjust the "serial communication setting"
(see the table "Serial communication" on page 2- 12.)
The Memory switch can be changed by either one of two methods:
• Memory switch setting utility
• Control by an ESC/POS command
Settings of the memory switch are stored in the NV memory; therefore, even if the printer is turned off, the
settings are maintained. Excessive use of this function may destroy the NV memory. As a guideline, do
not use this function more than 10 times a day.
When you use OPOS or APD, generally you don't need to adjust memory switch because OPOS or APD
are able to set these items automatically.
Memory Switch 8
SW Function
1 Status notice *1
2 Beeper tone for low battery
3 Beeper tone for host disconnection
4 Beeper tone when roll paper is out
5 Beeper tone when an error occurs
6 Paper position immediately after a specific
state
7 ~ 8 Reserved
* : Default setting
Note:
Msw 8-1:
When On is selected, this printer transmits power-off notice, power-on notice, and battery status to a host
PC. When off is selected, this printer doesn't transmit these.
Msw 8-2:
When On is selected, the printer beeps the buzzer for 10 seconds when the battery status enters "battery
level is L" or "battery level is S."
Msw 8-3, 8-4, 8-5:
When On is selected, the buzzer beeps for 10 seconds for each situation. For information on printer errors
(Msw 8-5), see "Error Types" on page 2- 1.
Rev. B
TM-P60 with Peeler Technical Reference Guide
On
Transmit s*
Beeps *
Beeps *
Beeps *
Beeps *
"Print starting position"
-
Off
Doesn't transmit
Doesn't beep
Doesn't beep
Doesn't beep
Doesn't beep
Not "Print starting
position"
-
2-11 Setup