Table of Contents
Advertisement
HOW TO USE
I. Place the sash belt across the child's
chest and through the sash guide in the
headrest.
The Sash Guide built in to the headrest
is used to position the sash portion of
the lap-sash seat belt across the child's
shoulders and chest.
Always use this sash guide.
J. Adjust lap and sash portion of seat
belt firmly but comfortably across the
child's lap and chest.
K. If using the Inertia Reel Retractor seat
belt, adjust the lap portion of the seat
belt firmly around the child and restraint,
then let the slack sash portion retract up
into the sash retractor.
IMPORTANT:
The SLIDEGUARD™ Converter must be used
when the child is using the Booster Seat.
Always ensure the seat belt is across the
child's thighs and across the chest.
TO REMOVE CHILD
Disengage seat belt tongue and buckle, remove the lap portion of seat belt from the SLIDEGUARD™
Clip and remove belt from child.
When Booster is not being used, secure in position, by engaging seat belt over the booster seat.
38
Instructions for Installation & Use - Series No. 8100/A/2010
Sash Guide
Lap part of seat
belt in recess area
must be under
armrests (if fitted)
on both sides.
Sash
Seatbelt
Sash Guide
HOW TO INSTALL WITH A CHILD HARNESS
USING WITH Safe-n-Sound™Protecta PLUS™HARNESS SERIES 220/2010
VERSATETHER™ compatible child harnesses are suitable with this child restraint and are sold
separately. Refer to the Harness instructions for full details of using and installing the Child Harness.
When installing the harness, connect its attachment clip to the VERSATETHER™ Catch on the Booster
Seat's upper tether strap (as shown in pages 42 and 43).
Use the extension strap (supplied with the Protecta PLUS™) for all other instances to attach the
harness to anchor points in the luggage area such as the vehicle floor or ceiling.
This Booster Seat is not suitable for child harnesses that are not VERSATETHER™compatible.
HEADREST POSITION:
Before installation ensure that the headrest is set to the correct height for your child (refer to page 8).
Headrest should be just above the child's shoulders.
I
The Child Harness shoulder straps
must be in the slots which are
nearest to the child's shoulders,
but not lower than the child's
shoulders.
Instructions for Installation & Use - Series No. 8100/A/2010
Harness
cross bar
Orange =Child Harness straps (over existing harness)
Green = In-built Harness (stored)
Black = Upper Anchorage Strap
39
Hide quick links:
Advertisement
Table of Contents
