Table of Contents
Advertisement
Maintaining Your Fireplace's Appearance
Fingerprints or other marks left on the optional gold surface may become etched in place if they
are not wiped clean prior to turning the fireplace on. Clean the gold with denatured alcohol and a
soft cloth (with the fireplace cool). Other cleaners may leave a film that may become etched into
the gold.
Yearly Service Procedure
•
Failure to inspect and maintain the fireplace may lead to improper combustion and a potentially dangerous
situation. We recommend the following procedures be done by a qualified technician.
1.
Check the pilot flame. It should touch approximately 3/8" of the top of the thermopile and touch the top of
the thermocouple (see illustration below). If it does not, contact your dealer for service.
2.
Shut off gas to the fireplace by turning the gas control knob to "OFF" (see step A under "Starting the Pilot"
on page 40). Let the fireplace cool for 15 minutes. Remove the faceplate (see page 38) and glass (see
page 32).
3.
Remove the log set (NOTE: the logs are very fragile - see page 34). If severely deteriorated, replace.
Check the logs for sooting. A small amount of soot along the bottom of the logs is normal. If excessive
sooting is found, the fireplace will require adjustment. Contact your dealer.
4.
Clean the burner (especially the burner holes) and inspect the following:
•
Make sure the burner is not warped, cracked, or damaged.
•
Check the firebox and area around the pilot to make sure there is no warping or damage.
•
If any problem is found, discontinue use and contact your dealer for service.
Before Disassembly -
Check the pilot flame. It
should touch the
thermocouple and
thermopile.
Thermopile
5.
Replace the log set. Clean and replace the glass (use non-abrasive cleaner - if damaged, replace). Make
sure the gasket along the perimeter of the glass contacts the face of the firebox and forms an air-tight seal.
If it does not, re-align or replace the gasket to insure an air-tight seal. Replace the faceplate.
6.
Inspect the area behind the access door. Clean if necessary. Check the gas control valve and the gas
lines. If damage is found, discontinue use and contact your dealer for service. Clean the air channels and
ducts.
7.
Start the pilot and turn on the main burner. The flames should be orange/yellow and not touch the top of the
firebox. If the pilot or main burners do not burn correctly, contact your dealer for service. Monitor the
blower operation.
8.
Remove any debris or vegetation near the vent termination. Contact your dealer if any sooting or
deterioration is found near the vent termination.
© Travis Industries
Maintenance
Check the walls and ceiling of the firebox for
deterioration.
Pilot Hood
Thermocouple
4060517
Check the burner holes.
43
Make sure the
burner is not
warped or
damaged.
100-01158
Advertisement
Table of Contents
