Face Installation And Removal - Travis Industries 21 DV RV User Manual

38
8. Attach the face following the directions below (see the directions included with the face for full
details).

Face Installation and Removal

The face has hooks that hold it in place. Make sure the face locks in place when installing.
PLATED SURFACES:
Make sure the plated surfaces are clean before starting
the fireplace. Any marks left on plated surfaces may
become etched in place. Clean plated surfaces with
denatured alcohol and a soft cloth.
ACID WASH WARNING: Before installing the faceplate, make sure any masonry that has been
treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid
wash (muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia
solution, the gold face may develop a permanent tarnish when the acid evaporates over time.
Contact your dealer if uncertain your facing has been properly neutralized.
9. Turn the flame adjust knob to its highest position - the flames should be approximately 10" tall.
Check the flame on low position. The flames should burn off of each burner hole. If the heater
does not work correctly, contact your dealer for a remedy.
10. Give this manual to the home owner and fully explain the operation of this heater.
© Travis Industries
Finalizing the Installation
4060517
b
Lift and rotate the face forward
until the top brackets lock into the
upper slots.
a
Tilt the face back
and insert the
bottom brackets
into the lower
slots until they
lock in place.
The bottom of the face is 1-1/4" below the
base of the fireplace when installed.
100-01158