Electrical Line Connection - Travis Industries 21 DV RV User Manual

14
Installation (for qualified installers only)

Electrical Line Connection

Remove the cover
a
from the fireplace
junction box.
Optional Electrical Line Location
Remove the eight screws securing the
a
access plate and electrical inlet
assembly (save these screws).
Electrical Inlet
Assembly
Position the electrical inlet assembly over the hole in
c
the baseplate of the fireplace and secure using the
screws removed in step "a".
© Travis Industries
Insert the sheathed cable from the power source through
b
this cable clamp. Once the wires are attached, tighten
the clamp to secure the cable.
Electrical
Connector
Attach the common (white), ground (exposed or green)
c
wires, and hot (black) wires from the power source to the
electrical connector (attached to the fireplace).
Access Plate
1/4" Nutdriver
1/4" Nutdriver
4060517
Standard
Screwdriver
WARNING: Make sure power is
off from the power lead before
conducting any wiring.
d
Remove the cover plate on the bottom
b
of the fireplace (save the nuts).
5/16" Wrench
Cover Plate
Attach the cover plate to the access plate using
d
the two nuts removed in step "b". Attach the
access plate to the fireplace using the screws
removed in step "a".
Replace the
cover removed
in step "a".
1/4" Nutdriver
5/16" Wrench
100-01158