Pro-Form Space Saver 895 ZLE User Manual page 8

5. While another person holds the Upright (3) near
the Frame (1), connect the Upper Wire Harness
(48) to the Lower Wire Harness (49).
Insert the Upright (3) into the Frame (1).
Tip: Avoid pinching the wires. Attach the
Upright (3) with an M8 x 69mm Button Bolt (80),
an M8 Split Washer (90), and an M8 Jam Nut
(79). Do not tighten the Button Bolt yet;
make sure that the Jam Nut is in the hexago-
nal hole in the Frame.
Next, finger tighten two M8 x 23mm Button
Screws (84) with M8 Split Washers (90) into the
Frame (1). Do not tighten the Button Screws
yet.
Attach the Water Bottle Holder (22) to the
Frame (1) with two M4 x 16mm Screws (104).
6. The Console (5) can use four D batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the battery cover, insert the
batteries into the battery compartment, and
reattach the battery cover. Make sure to orient
the batteries as shown by the diagram
inside the battery compartment.
To purchase an optional AC adapter, contact
the store where you purchased this product
or call the telephone number on the cover of
this manual. To avoid damaging the console,
use only a manufacturer-supplied AC
adapter. Plug one end of the AC adapter into
the jack on the console; plug the other end into
an outlet installed in accordance with all local
codes and ordinances.
5
80
90
Hexagonal
Hole
90
84
6
Batteries
5
8
Avoid pinching
the wires
3
48
49
79
90
84
104
22
1
Cover